1,502
edits
Difference between revisions of "Compiling ScummVM/Visual Studio"
Compiling ScummVM/Visual Studio (view source)
Revision as of 14:48, 17 May 2009
, 14:48, 17 May 2009Updates for some libraries
(Updated the precompiled libraries link) |
(Updates for some libraries) |
||
| Line 64: | Line 64: | ||
Now, we need to compile the required libraries. | Now, we need to compile the required libraries. | ||
Note that you'll need to build all libraries with the same configuration settings (debug or release). If you don't need a specific library, you can remove it from your build by going to Project->Properties, Configuration Properties->C/C++->Preprocessor and remove the "USE_XXX" directive for that library from there. For example, to remove OGG support, remove the USE_VORBIS directive | Note that you'll need to build all libraries with the same configuration settings (debug or release). If you don't need a specific library, you can remove it from your build by going to Project->Properties, Configuration Properties->C/C++->Preprocessor and remove the "USE_XXX" directive for that library from there. For example, to remove OGG support, remove the USE_VORBIS directive. | ||
Also, make sure to disable the inclusion of default libraries in all libraries. You can do this from the project properties->Librarian->General and setting "Ignore all default libraries" to "Yes (/NODEFAULTLIB)" (special thanks to nolange for this tip). Finally, make sure that optimization is set to "Maximize speed" (or anything other than "Full optimization"), otherwise it will be impossible to build incremental debug builds later on (you'll get a warning saying "ignoring '/INCREMENTAL' due to '/LTCG' specification"). You can do this from the project properties->C/C++->Optimization, and set "Optimization" to "Maximize Speed (/O2)" | |||
| Line 126: | Line 128: | ||
=== FLAC === | === FLAC === | ||
Open its solution and compile the libFLAC_static project. | Open its solution and compile the libFLAC_static project. By default, optimization for this library is set to "full" in release builds, which will prevent you from performing incremental debug builds later on, so make sure to set it to "Maximize speed" (or anything other than "Full optimization"), otherwise it will be impossible to build incremental debug builds later on. Check the introductory section for more information. Also, FLAC OGGs are not needed, so support for these can be dropped by going to the libFLAC_static project settings and removing the FLAC__HAS_OGG switch from C/C++->Preprocessor->Preprocessor Definitions. | ||