AGIWiki/block

The block command programmatically creates an invisible rectangular block to restrict screen object movement.

block(number left, number top, number right, number bottom);

Objects on the screen are not allowed to cross the borders of the block (regardless of whether they are inside the block or outside), unless an ignore.blocks command has been issued for that object.

Note: There can be only one block on the screen at a time. If the block command is issued when a block already exists, the new block will replace the old one.

The unblock command will remove the block without replacing it with a new one.

Parameters

left: a number, 0-255, specifying the x-coordinate of the left side of the block rectangle, in graphics coordinates
top: a number, 0-255, specifying the y-coordinate of the top side of the block rectangle, in graphics coordinates
right: a number, 0-255, specifying the x-coordinate of the right side of the block rectangle, in graphics coordinates
bottom: a number, 0-255, specifying the y-coordinate of the bottom side of the block rectangle, in graphics coordinates

Possible errors

(Unknown)

Examples

The following code creates a block rectangle whose top-left corner is at (10, 25) and whose bottom-right corner is at (100, 120): <syntax type = "C++">

block(10, 25, 100, 120);

</syntax>

Technical Information

Required interpreter version	Available in all AGI versions
Bytecode value	90 (0x5A hex)

Sources

AGI Studio help file
WinAGI help file